Electrical Circuits

Electrical tours SUMMARY Unlike the last lab on RL, RC and RLC circuits, we measured the frequency characteristics of these circuits. We observed the steady-state sinusoidal response of an high-pass RL circuit, a low-pass RC circuit and a band-pass RLC circuit. PROCEDURE 10.4.1 Steady-State Sinusoidal Response of High-Pass RL circumference This part of the lab consisted of constructed an high-pass RL circuit shown below in purpose 10.1. We utilise the scope to measure the phase and the gain of the circuit. Also, we apply the Gain-Phase meter to measure the phase and the gain of the circuit. Figure 10.1: High-pass RL circuit. A Bode plot is shown below from the measurements of the scope, gain in dB versus record f and, separately, phase shift in degrees versus lumber f.

90 Y = 90? 20log|jw| -20log |1+j (w/170212)| AdB,q 0 -90 -b = -tan-1(w/170212) 170212 log f 10.4.3 ...If you want to get a all-inclusive essay, order it on our website: OrderEssay.net

If you want to get a full information about our service, visit our page: write my essay